How to Hack Wi-Fi easily–Ultimate guide

Many of my buddies request me to update a working Wi-Fi-hacking process. ( you can also request any tricks you want .  contact us by using contact form at the end of the page ). So Here I am going to teach you how you can easily Hack your neighbor's  protected Wi-Fi . Wireless hot spots (Wi-Fi can be found everywhere!  if you have a PC with a wireless network card ,  then you must have seen many networks around you . but  unfortunately almost all of that are secured with a network security key.  With the trick I am going to give you, you can easily hack a secured Wi-Fi and access internet for free. 

What You Need

1. A compatible wireless adapter :

In this process we are using a software name CommView to hack Wi-Fi . So it is highly recommended that you must have a compatible wireless card with CommView. This is to ensures that the wireless card can go into monitor mode which is essential for capturing packets ( Main part of the process). Click here to check the compatibility of your wireless card .

2. CommView (Software use to capture packets) :

you must download this software which is used to capture the packets from desired network adapter.  you can download the software easily from here .

3. Aircrack-ng GUI (Software used for cracking):

Aircrack-ng GUI is a software used for actual cracking of packets  captured using commview.  Download Aircrack-ng GUI here.

Step 1 : Setting Up CommView

• After downloading Zip file of  CommView for  wifi  , Extract it and run the setup.exe . An installation guidewill open when you first rum CommView . Follow the prompts to install the driver for your wireless card.
• Run CommView for Wi-Fi and click the play icon on the top left of  the CommView window . it will starts scanning for Wi-Fi near you .

 

• After few minutes you will see a list of wireless network near you with their signal and security type . Choose a desired target network that you want to crack. ( Choose only WEP network with the highest signal).
• After choosing desired network , click capture to start capturing packets from the desired channel.

            

Step 2 :   Wait until packets captured.

Now you have to wait for the packets to being captured. this step needs patience. you should  have to capture minimum  100,000 packets for a decent signal. After collecting enough data , Follow the steps given below: 

• Go to the log tab and click on concatenate logs.
• Select all the logs that have been saved.
• Do not close CommView for wifi.
• Now navigate to the folder where the concatenated logs have been saved.
• open the log file. Select File – export – wire shark  tcpdump format and choose any suitable destination. Now your logs will be saved with .cap extension.

 

                  

Step 3 : CRACKING

Now you have to use the software you downloaded before  i.e  Aircrack-ng GUI . Extract the zip file of Aircrack-ng GUI . After extracting… 

• Run Aircrack-ng GUI .
• Choose WEP and Open your .cap  file that you have saved before .

• Click launch  and type the index number of your target wireless network in command prompt.
• After that all you have to do is Wait .

If everything goes fine the wireless key will be shown. 

Please Share Us on any given below social sites to help us and make us continue to bring such unique article for you. your share will be appreciated.
Note : It may request you to try with more packets . In that case capture more packets and perform cracking again . Stay tuned with us for our future post on How To Hack Wifi Using 
GOOD LUCK …

SITE MAP