Many of my buddies request me to update a working Wi-Fi-hacking process.
( you can also request any tricks you want . contact us by using
contact form at the end of the page ). So Here I am going to teach you
how you can easily Hack your neighbor's protected Wi-Fi . Wireless hot
spots (Wi-Fi can be found everywhere! if you have a PC with a wireless
network card , then you must have seen many networks around you . but
unfortunately almost all of that are secured with a network security
key. With the trick I am going to give you, you can easily hack a
secured Wi-Fi and access internet for free.
What You Need
1. A compatible wireless adapter :
In this process we are using a software name CommView to hack Wi-Fi . So it is highly recommended that you must have a compatible wireless card with CommView. This is to ensures that the wireless card can go into monitor mode which is essential for capturing packets ( Main part of the process). Click here to check the compatibility of your wireless card .2. CommView (Software use to capture packets) :
you must download this software which is used to capture the packets from desired network adapter. you can download the software easily from here .
3. Aircrack-ng GUI (Software used for cracking):
Aircrack-ng GUI is a software used for actual cracking of packets captured using commview. Download Aircrack-ng GUI here.Step 1 : Setting Up CommView
- After downloading Zip file of CommView for wifi , Extract it and run the setup.exe . An installation guide will open when you first rum CommView . Follow the prompts to install the driver for your wireless card.
- Run CommView for Wi-Fi and click the play icon on the top left of the CommView window . it will starts scanning for Wi-Fi near you .
- After few minutes you will see a list of wireless network near you with their signal and security type . Choose a desired target network that you want to crack. ( Choose only WEP network with the highest signal).
- After choosing desired network , click capture to start capturing packets from the desired channel.
Step 2 : Wait until packets captured.
Now you have to wait for the packets to being captured. this step needs patience. you should have to capture minimum 100,000 packets for a decent signal. After collecting enough data , Follow the steps given below:
- Go to the log tab and click on concatenate logs.
- Select all the logs that have been saved.
- Do not close CommView for wifi.
- Now navigate to the folder where the concatenated logs have been saved.
- open the log file. Select File – export – wire shark tcpdump format and choose any suitable destination. Now your logs will be saved with .cap extension.
Step 3 : CRACKING
Now you have to use the software you downloaded before i.e Aircrack-ng GUI . Extract the zip file of Aircrack-ng GUI . After extracting…- Run Aircrack-ng GUI .
- Choose WEP and Open your .cap file that you have saved before .
- Click launch and type the index number of your target wireless network in command prompt.
- After that all you have to do is Wait .
